Skip to content
TrySitePrice

Linux Use smartctl To Check Disk Behind Adaptec RAID Controllers

Best/Tutorial

To check the health status of disks behind Adaptec RAID controllers in Linux, you can use the smartctl utility. Here's how:

  1. Install the smartmontools package, if it's not already installed, by running the following command:
sudo apt-get install smartmontools (for Debian-based systems)

or

sudo yum install smartmontools (for Red Hat-based systems)

  1. Find the device file for the disk behind the Adaptec RAID controller by running the following command:
ls -l /dev/disk/by-id/
  1. Use the device file to run the smartctl command, for example:
sudo smartctl -a /dev/sdb
  1. The output of the smartctl command will display the health status of the disk, including the overall health status, temperature, and any reported errors or failures.
rnNote: The exact device file name may vary depending on your setup. The /dev/sdb in the above example is just an example, and you should use the actual device file name for your disk.