CentOS / RHEL IPv6 ip6tables Firewall Configuration

by

To configure the ip6tables firewall in CentOS/RHEL to allow IPv6 traffic, you can follow these steps:

  1. Check the current ip6tables rules by running the following command:
    sudo ip6tables -L -n

    This will display the current rules in the ip6tables firewall.

  2. Allow inbound and outbound traffic on the loopback interface by running the following commands:
    sudo ip6tables -A INPUT -i lo -j ACCEPT
    sudo ip6tables -A OUTPUT -o lo -j ACCEPT

    These commands allow traffic on the loopback interface, which is used for local communication between applications on the same machine.

  3. Allow traffic related to established connections by running the following command:
    sudo ip6tables -A INPUT -m conntrack --ctstate ESTABLISHED,RELATED -j ACCEPT

    This command allows traffic related to established connections, which means that if a connection was initiated from inside the server, the responses to that connection will be allowed.

  4. Allow incoming SSH connections by running the following command:
    sudo ip6tables -A INPUT -p tcp --dport 22 -j ACCEPT

    This command allows incoming SSH connections, which is necessary if you need to remotely connect to the server.

  5. Allow any other incoming traffic that is needed by your server, for example, HTTP or HTTPS traffic. You can do this by adding additional rules to the ip6tables firewall.
  6. Save the ip6tables rules by running the following command:
    sudo service ip6tables save

    This will save the current ip6tables rules, so they will be applied the next time the system is booted.

That’s it! With these rules in place, the ip6tables firewall should be configured to allow the necessary IPv6 traffic on your CentOS/RHEL server. bellevuehealthcare.com

Leave a Comment